Signal app 503 error1/16/2024 ![]() Close out of the Rain Bird App on all mobile devices and wait approximately 30 seconds before accessing the controller from a single device. Solution: Only a single device can connect to the controller at one time. Issue: Controller will not connect to mobile device and Rain Bird App is displaying “Communication 503” error. Close out of the Rain Bird App and wait approximately 30 seconds before accessing the controller from your mobile device. Solution: Verify that your virtual private network (VPN) is toggled off in the mobile device settings. Issue: Controller will not connect to mobile device and Rain Bird App is displaying “Communication Error.” Launch the setup wizard in the Rain Bird App by tapping the “Add Controller” icon and follow the on-screen instructions. Solution: Press the PAIRING MODE button on the controller interface and wait for the LED to start blinking blue (if a local network is available) or alternating red and green (if a local network is not available). Issue: Controller is not connected to a mobile device and STATUS on controller interface is blinking red. To reset WiFi, follow the “Reset only WiFi settings back to Quick Pair broadcast mode” instructions in this article. Solution: You will need reset your WiFi on the controller interface. Issue: Controller was previously set up in AP Hotspot Mode by another user and the controller interface is blinking alternating red and green, and I want to connect to my WiFi network for the first time. Solution: The controller needs to be connected to your mobile device for the first time, or if you have previously connected to the controller from your mobile device but it is still not connecting, you will need reset your WiFi on the controller interface. Issue: Controller is not connected to mobile device and STATUS on controller interface is solid green. To connect a mobile device to the controller, launch the Rain Bird App, tap the “Add Controller” icon and follow the on-screen instructions. Solution: The controller needs to be connected to your mobile device for the first time. Issue: Controller is not connected to mobile device and STATUS on controller interface is blinking blue. If needed, boost signal by adding a wireless router or moving controller and router closer together. Ideally, the controller should have -30 to -60 Received Signal Strength Indicator (RSSI). ![]() This can be done in the Rain Bird App by clicking the WiFi Signal Strength icon in your controller settings. Solution: Verify with your mobile device the WiFi signal has at least two bars of strength at the location of the controller. Connection issues between mobile device and controller: ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |